Navigation:  Programmer's Reference > Sending data to DPlot from another application >

XYZ_To_XY macro command

Print this Topic Previous pageReturn to chapter overviewNext page

Macro commands may be used either in macros or by sending the commands to DPlot via dynamic data exchange (DDE). Some commands are valid only in macros (noted by Macros Only). Commands sent to DPlot via DDE must be enclosed by square brackets [     ]. Macro commands should not include the brackets.

Command parameters shown in the descriptions below are placeholders for the actual values. Command parameters are either numeric values, equations that evaluate to numbers, or character strings. Character string parameters are always bound by double quotation marks. Equations must be preceded by an equals sign (=).

The pipe symbol (|) in the command syntax indicates that a parameter is optional, and should not be included in your macro unless otherwise noted.

All indices into arrays are 1-based, e.g. Curve1=1 refers to the first curve in a plot.

A 0x prefix for numbers in the descriptions below indicates hexadecimal notation; e.g. 0x0010 = 16.

JR/Viewer indicates that the command is supported by DPlot Jr or DPlot Viewer.
JR/Viewer indicates that the command is NOT supported by DPlot Jr or DPlot Viewer.



JR   Viewer

Creates an XY plot from the intersection of a vertical plane with the active 3D surface plot. This command is equivalent to the XY Plot from 3D Surface menu command.

The first parameter (method)gives the method for specifying the intersection plane and must be 0, 1, or 2. For a line Y=mX+b use

For a constant X plane, use

and to define the plane with two points (x1,y1) and (x2,y2) use


Page url: