Navigation:  Programmer's Reference > Sending data to DPlot from another application >

TextPointLabelLeader macro command

Print this Topic Previous pageReturn to chapter overviewNext page

Macro commands may be used either in macros or by sending the commands to DPlot via dynamic data exchange (DDE). Some commands are valid only in macros (noted by Macros Only). Commands sent to DPlot via DDE must be enclosed by square brackets [     ]. Macro commands should not include the brackets.

Command parameters shown in the descriptions below are placeholders for the actual values. Command parameters are either numeric values, equations that evaluate to numbers, or character strings. Character string parameters are always bound by double quotation marks. Equations must be preceded by an equals sign (=).

The pipe symbol (|) in the command syntax indicates that a parameter is optional, and should not be included in your macro unless otherwise noted.

All indices into arrays are 1-based, e.g. Curve1=1 refers to the first curve in a plot.

A 0x prefix for numbers in the descriptions below indicates hexadecimal notation; e.g. 0x0010 = 16.

JR/Viewer indicates that the command is supported by DPlot Jr or DPlot Viewer.
JR/Viewer indicates that the command is NOT supported by DPlot Jr or DPlot Viewer.



JR   Viewer

Specifies the arrowhead width and height and the line used in point labels, in 1000ths of inches. The default arrowhead size is 150 (0.15 inches) tall by 75 wide. The default line width is 0 (1 pixel/printer dot). Default values will be used for 0 or omitted values. If the arrowhead height is set to a negative number, arrowheads will not be drawn. If the line width is set to a negative number, neither line segments nor arrowheads will be drawn.


See also

Label Points menu command


Page url: