Navigation:  Programmer's Reference > Sending data to DPlot from another application >

TextNoteLeader macro command

Print this Topic Previous pageReturn to chapter overviewNext page

Macro commands may be used either in macros or by sending the commands to DPlot via dynamic data exchange (DDE). Some commands are valid only in macros (noted by Macros Only). Commands sent to DPlot via DDE must be enclosed by square brackets [     ]. Macro commands should not include the brackets.

Command parameters shown in the descriptions below are placeholders for the actual values. Command parameters are either numeric values, equations that evaluate to numbers, or character strings. Character string parameters are always bound by double quotation marks. Equations must be preceded by an equals sign (=).

The pipe symbol (|) in the command syntax indicates that a parameter is optional, and should not be included in your macro unless otherwise noted.

All indices into arrays are 1-based, e.g. Curve1=1 refers to the first curve in a plot.

A 0x prefix for numbers in the descriptions below indicates hexadecimal notation; e.g. 0x0010 = 16.

JR/Viewer indicates that the command is supported by DPlot Jr or DPlot Viewer.
JR/Viewer indicates that the command is NOT supported by DPlot Jr or DPlot Viewer.



JR   Viewer

Specifies the arrowhead height and width and line width used for lines drawn from text notations to referenced X,Y|,Z| coordinates when the N_ARROW bit of the Flags argument to a TextNoteEx or TextNote3D command is set. All dimensions are in 1000ths of inches. If ArrowH is omitted or set to 0, the default height of 0.15 inches is used. If you do not want an arrowhead, set ArrowH to -1. If ArrowW is omitted or set to 0, one half the arrow height will be used.


See also

Add/Edit Note menu command


Page url: