DPlot Forum Index DPlot
http://www.dplot.com
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

what are default values for maxc and maxp parameters?

 
Post new topic   Reply to topic    DPlot Forum Index -> Suggestions/Questions
View previous topic :: View next topic  
Author Message
zigiotto



Joined: 10 Aug 2004
Posts: 1
Location: Brazil

PostPosted: Tue Aug 10, 2004 9:22 am    Post subject: what are default values for maxc and maxp parameters? Reply with quote

Hi.

If I don't set those values with "FileArrays" command, what are the default number of curves and points per curve?

I am using DPlot Jr. v. 1.9.6.7, and the "XY(x,y)" command to send data.

Thank you.

Zigiotto
Back to top
View user's profile Send private message
DPlotAdmin
Site Admin


Joined: 24 Jun 2003
Posts: 2310
Location: Vicksburg, Mississippi

PostPosted: Tue Aug 10, 2004 9:29 am    Post subject: Reply with quote

100x1000, but those change anytime you (or in your case, the user) force the array sizes by double-clicking the status bar or using File>Resize Arrays. Those values get saved to an ini file and are restored the next time you run DPlot/DPlot Jr. Since you can't know what your end user has been up to, it's best to force the size with a [FileArrays()] command.
_________________
Visualize Your Data
support@dplot.com
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    DPlot Forum Index -> Suggestions/Questions All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group