SymbolOutlineColor command

Macro commands may be used either in macros or by sending the commands to DPlot via dynamic data exchange (DDE). Some commands are valid only in macros (noted by Macros Only). Commands sent to DPlot via DDE must be enclosed by square brackets [ ]. Macro commands should not include the brackets.

Command parameters shown in the descriptions below are placeholders for the actual values. Command parameters are either numeric values or character strings; character string parameters are always bound by double quotation marks.

All indices into arrays are 1-based, e.g. Curve1=1 refers to the first curve in a plot.

A 0x prefix for numbers in the descriptions below indicates hexadecimal notation; e.g. 0x0010 = 16.

JR/Viewer indicates that the command is supported by DPlot Jr or DPlot Viewer.
JR/Viewer indicates that the command is NOT supported by DPlot Jr or DPlot Viewer.

[SymbolOutlineColor(index,color)]

JR Viewer

Sets the color for the index'th curve of an XY plot to the color (blue*256+green)*256+red, where the red, green, and blue components range from 0 to 255. color may use hexadecimal notation: 0x00FF80 represents red=128, green=255, blue=0. If index = -1, then color is used for ALL curves. This command automatically turns SymbolOutline on.