ProbabilityFlags command

Macro commands may be used either in macros or by sending the commands to DPlot via dynamic data exchange (DDE). Some commands are valid only in macros (noted by Macros Only). Commands sent to DPlot via DDE must be enclosed by square brackets [ ]. Macro commands should not include the brackets.

Command parameters shown in the descriptions below are placeholders for the actual values. Command parameters are either numeric values or character strings; character string parameters are always bound by double quotation marks.

All indices into arrays are 1-based, e.g. Curve1=1 refers to the first curve in a plot.

A 0x prefix for numbers in the descriptions below indicates hexadecimal notation; e.g. 0x0010 = 16.

JR/Viewer indicates that the command is supported by DPlot Jr or DPlot Viewer.
JR/Viewer indicates that the command is NOT supported by DPlot Jr or DPlot Viewer.

[ProbabilityFlags(flags)]

JR Viewer

Changes the appearance of probability plots. Flags is a combination of:

0x0001

For probability scales on the X axis, do not draw an inverted scale at the top of the plot. The default is to draw that scale.

0x0002

For probability scales on the Y axis, do not draw an inverted scale on the right side of the plot. The default is to draw that scale.

0x0004

Input values range from > 0 (no chance) to < 1 (certainty). If not set, input values range from > 0 to < 100.

Page url: http://www.dplot.com/help/index.htm?probabilityflagscommand.htm