Navigation:  Programmer's Reference > Sending data to DPlot from another application >

InsertXY macro command

Print this Topic Previous pageReturn to chapter overviewNext page

Macro commands may be used either in macros or by sending the commands to DPlot via dynamic data exchange (DDE). Some commands are valid only in macros (noted by Macros Only). Commands sent to DPlot via DDE must be enclosed by square brackets [     ]. Macro commands should not include the brackets.

Command parameters shown in the descriptions below are placeholders for the actual values. Command parameters are either numeric values, equations that evaluate to numbers, or character strings. Character string parameters are always bound by double quotation marks. Equations must be preceded by an equals sign (=).

The pipe symbol (|) in the command syntax indicates that a parameter is optional, and should not be included in your macro unless otherwise noted.

All indices into arrays are 1-based, e.g. Curve1=1 refers to the first curve in a plot.

A 0x prefix for numbers in the descriptions below indicates hexadecimal notation; e.g. 0x0010 = 16.

JR/Viewer indicates that the command is supported by DPlot Jr or DPlot Viewer.
JR/Viewer indicates that the command is NOT supported by DPlot Jr or DPlot Viewer.


 

[InsertXY(index,xnew,ynew)]

JR   Viewer

Adds a data point to the curve selected with the SelectCurve command at the 1-based index'th position. If index is greater than the current number of points in this curve, the new point is simply appended to the end of the curve as with the XY command. Returns an error for index < 0. If this operation would cause the number of points in the curve to exceed the array sizes (set with FileArrays), DPlot returns DDE_FNOTPROCESSED to a DDE client, or causes an error in the DPlot macro facility.

 


Page url: https://www.dplot.com/help/index.htm?insertxycommand.htm