|
GrainSizeOther macro command |
  
|
|
GrainSizeOther macro command |
|
Macro commands may be used either in macros or by sending the commands to DPlot via dynamic data exchange (DDE). Some commands are valid only in macros (noted by Macros Only). Commands sent to DPlot via DDE must be enclosed by square brackets [ ]. Macro commands should not include the brackets.
Command parameters shown in the descriptions below are placeholders for the actual values. Command parameters are either numeric values or character strings; character string parameters are always bound by double quotation marks.
All indices into arrays are 1-based, e.g. Curve1=1 refers to the first curve in a plot.
A 0x prefix for numbers in the descriptions below indicates hexadecimal notation; e.g. 0x0010 = 16.
JR/Viewer indicates that the command is supported by DPlot Jr or DPlot Viewer.
JR/Viewer indicates that the command is NOT supported by DPlot Jr or DPlot Viewer.
[GrainSizeOther(size1,"text1"|,size2,"text2"|, |
|
Specifies from 1 to 4 custom sieve sizes to use on grain size distribution plots. size is the sieve size in millimeters, text is the label that will be used for this sieve. Note that these sieve sizes will not be drawn unless the corresponding bits in a GrainSizeFlagsEx command are set, or the corresponding checkboxes on the Grain Size Distribution Plot Options dialog are checked.
Page url: http://www.dplot.com/help/index.htm?grainsizeothercommand.htm